Tune in to Your Transmission

Posted: December 1, 2012

Ignore it, and sooner or later it will fail you.

By: Deane Hislop

The transmission in your boat is the vital link between the engine and the prop, yet many boat owners never pay attention to their transmission until it’s too late. A review of the owner’s transmission manual will give you all the information you need regarding the “care and feeding” of your transmission. If you have any questions not covered in the manual, check the transmission manufacturer’s website.

 

Inspecting the outside of the transmission and taking appropriate action can prevent failures. Oil or seawater dripping onto the transmission can gum up or corrode vital shift linkage and shift control components.

 

Most pleasureboaters will not meet the operating-hour oil-change interval. In that case, the owner should plan on changing the oil and the filter once a year. Clean oil is cheap insurance. Use genuine filters and recommended oils. While OE filters might be more expensive, they’re specified because they have been tested by the factory to meet the explicit needs of the transmission. Utilizing non-original parts or the wrong lubricants may reduce component life and could possibly harm the transmission.

 

Transmissions don’t burn oil, and that constant level is one reason boat owners neglect to check the oil. However, checking the oil level and checking the bilge for any sign of an oil leak are essential to effective transmission maintenance. An oil leak can occur and not be detected, even if you inspect the bilge for the presence of oil, because of where leaks occur: at the front and rear seals and at the oil cooler. Leaks in the first two areas can be spotted in the bilge, but a leak in the oil cooler does not leave oil in the bilge.

 

The most common leaks are in the rear shaft seal. They often occur simply because of the location of this seal in the boat — low down and close to the shaft log and stuffing box, where salt water often seeps in and is splashed around, drenching the transmission output shaft. This can cause corrosion and pitting in the output shaft, and seal leaks can develop. Keeping water out of the bilge prevents this from happening.

 

Oil coolers are almost always mounted on some area of the transmission. Smaller transmissions have coolers with external oil lines that can develop leaks, and all oil coolers can develop cracks through which oil can leak. These leaks are particularly dangerous, because they cannot be seen. Oil leaks into the water side of the cooler and exits the exhaust. Due to the higher pressure on the oil side of the cooler, a pinhole leak can drain a transmission in a matter of hours. Only by checking the oil level will evidence of such a leak be detected.

 

Transmission oil-cooler zincs should be changed when engine zincs are changed, and coolers should be cleaned and tested when the engine cooling system is serviced.

 

captcha 8478c431668a4c9ea311f087e0acf536
 

Free Digital Guide to Pacific Coast Marinas